The Atlas 414 is a 4 post lift with 14,000 pounds of lift capacity designed for commercial use.

This lift is designed and built to commercial grade standards and will provide many years of service.

The Atlas 414 uses a high strength cable system (with a under runway oversized hydraulic cylinder) powered by a 220 volt (single phase) power unit to raise and lower the lift.

Many competitors use an “old style” chain lifting system with an exposed hydraulic cylinder system. Old style chain lifts are difficult to “level” properly and the exposed hydraulic cylinder is responsible for numerous “door dings”.

Finally, the Atlas 414 features “tracks” between the runways to allow the use of a rolling bridge jack (such as the Atlas RJ8000BK) on the lift. Rolling jacks sold separately.

Features & Benefits

14,000 lb. Capacity
Heavy Duty, Commercial Grade
Extra Tall, Extra Wide & Extra Long
Diamond Plated Runways
Air Operated Single Point Lock Release (External Air Supply Required)
Lock Ladder Design
Double Lock Safety System
Powder Coat Finish
Steel Approach Ramps Included
Additional Drive off Ramps Available (Sold Separately)
Runway Extensions Available (Sold Separately)
Mounting Hardware Included
220volt/1phase Electric Operation (Requires a 30amp Breaker)
5 yr Structural – 2 yr Hydraulic Warranty

Atlas ATTD-414 Specifications

Capacity	14,000 lb.
Lifting Height	80″ (6′ 8″)
Overall Width Of Columns (Without Motor)	130 7/8″ (10′ 10 7/8″)
Overall Width Of Columns (With Motor)	138 7/8″ (11′ 6 7/8″)
Overall Length With Approach Ramp	255″ (21′ 3″)
Length Between Columns	197 1/4″ (16′ 5 1/4″)
Runway Length	208 5/8″ (17′ 4 5/8″)
Runway Width	20″
Thickness Of Runway	8 3/4″
Width Between Runways	46 7/8″ (w/ Rail 44 3/8″)
Outside Runway To Outside Runway	86 7/8″ (7′ 2 7/8″)
Clearance Under Runways	71 1/4″ (5′ 11 1/4″)
Clearance Between Columns	116″ (9′ 8″)
Height Of Columns	91 1/8″ (7′ 7 1/8″)
Maximum Wheel Base	197″ (16′ 5″)
Drive Thru	102 1/8″ (8′ 6 1/8″)
Air Requirement	85-115 PSI (EXTERNAL AIR SUPPLY REQUIRED)
Motor/Electrical Requirement	220 volt single (1) phase.A 30-amp breaker is recommended
Oil Requirement	3-5 GallonsAW32/AW46 (NOT INCLUDED)